Home|Contact Us|Suppliers|Employee Information|Site map|My Account
Narda-MITEQ

Model: AM-1626-2000

Get A Quote
Description:Amplifier
Specifications at23 °C:
Frequency:0.0001 to 2 GHz
Gain:20 dB min.
Gain Flatness:1 dB+/- max.
Noise Figure:4.2 dB max.
Noise Temperature:389.8 K max.
VSWR In:2:1 max.
VSWR Out:2:1 max.
P1dB Out:14 dBm min.
Output IP3 Typ.:24 dBm
Voltage:15 V nom.
Current:95 mA nom.
Outline Drawing:179685-1
Operating Temp:-30 to 75 °C
Get A Quote

Documents for AM-1626-2000

Outline Drawing: 179685 (PDF)

ITAR: NO
Similar Models
AM-1626-1000

Available Options for AM-1626-2000:

OptionDescriptionDetails
-FInput Bias TeeAvailable on most units operating above 1 MHz and in outlines 1-5, 6-10, 12, 13 & 15. Used to inject DC bias to photo diode or other type of device. To order, add “-F” after model number. Example: AU-2A-0150-F. Bias connector is a filtered solder pin. SMA-Female is abailable on request.
-1306Bias Via Output RF Center ConductorUsed to supply operating power when amplifier is remotely located. Eliminates the need to run a separate DC line. Option 1306 will have the existing +15V power pin existing pin enabled for use as a test point. Shipped with the DC power pin insulated to prevent accidental shorting to ground and subsequent damage to the internal bias choke. Use caution with this option since any voltage applied here will also be present on the RF output center pin. Not available on all models.
-1334Bias Via Output RF Center Cond., DC Feed-Thru to RF Input Center Cond. (existing power enabled)Used to supply operating power when amplifier is remotely located. Eliminates the need to run a separate DC line. This DC voltage is then internally fed to the RF input to power a remote LNA or other low power equipment. Maximum current of external load will vary with model. Please call for specs prior to ordering. Option 1334 will have the existing +15V power pin existing pin enabled for use as a test point. Shipped with the DC power pin insulated to prevent accidental shorting to ground and subsequent damage to the internal bias choke. Use caution with this option since any voltage applied here will also be present on the RF output center pin. Not available on all models.
-1103Internal Limiter (For Frequencies to 500 MHz)Will protect the input stage from CW signals as high as +30 dBm and short duration pulses (<10 µSec 20V Peak). To order, add -1103 after model number. Example: AU-2A-0150-1103.
-NType "N-Female" Connector (Pair)Type BNC-Female and N-Female are available for all amplifiers using outlines 1-5, 12, 13 & 15. Add connector type after model number. Example: AU-2A-0150-BNC. Type N-Male, TNC-Female, and mixed connector types are available on request. Please call MITEQ with your specific requirements.
-BNCType "BNC-Female" Connector (Pair)Type BNC-Female and N-Female are available for all amplifiers using outlines 1-5, 12, 13 & 15. Add connector type after model number. Example: AU-2A-0150-BNC. Type N-Male, TNC-Female, and mixed connector types are available on request. Please call MITEQ with your specific requirements.
-AS12NA12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, North America
-AS12EU12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Europe
-AS12KR12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Korea
-AS12UK12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, United Kingdom
-AS12SAA12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Australia and China
-AS12AR12V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Argentina
-AS15NA15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, North America
-AS15EU15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Europe
-AS15KR15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Korea
-AS15UK15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, United Kingdom
-AS15SAA15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Australia and China
-AS15AR15V, 1-Amp regulated wall plug-in power supply, 100-240V 50-60 Hz, Argentina
-1179Integral Power Supply (100-240 VAC, 47-440 Hz)Available as an add-on to most models using catalog outline 1-5 & 15. Unit has On/Off Switch, LED indicator & Internal Fuse. Refer to outline #12 for dimensions. To order, add -1179 after model number. Example: AU-2A-0150-1179.
-1179SCWall Plug-In Power Supply with SMC ConnectorsSame as above except has mating SMC connectors on amplifier DC input and power supply DC output. Available for outlines 1-5, 6-10, 13 & 15. See photo.

Options may not apply to all models.